County Line 22 Ton Log Splitter Won't Start

Check that the log is positioned correctly and that it doesn’t exceed the maximum dimensions for your log splitter. I am having problems keeping my log splitter engine running.

Buyziplinekitsnow Buyziplinekitsn - Profile Pinterest

Set the pump lever in the neutral position.

County line 22 ton log splitter won't start. The splitter has been really nice. I have been doing a bunch of oak with it and having to split vertically with a bunch of it as some of the rounds are up to 34. How to adjust the pump pressure on a log splitter start the engine on your log splitter as you normally would.

I’ve never run into a log it will not split—including some cottonwood over 30”. If you left gas in the fuel tank for more than 6 months without adding fuel stabilizer, drain the tank and fill it with fresh gas. Start the engine and allow it to run for 15 minutes before reconnecting the sensor.

You may need to replace the oil filter if it is old and worn out. I got rid of the old gas and refilled it with fresh gas, changed the air filter and spark plug and it still won't run. It can handle logs 24″ long and weighing up to 100 lbs.

I was using it the other day and noticed a couple of wear spots on the sides of the inside. The 25 ton county line/tsc is at the top of my list; I read numerous complaints about this.

This will ensure you buy the exact part of your hydraulic log splitter. Stale gas won't start the engine. The power that drives the hydraulic wedge of a wood splitting machine comes from a small engine similar to that you'd find on a lawn mower.

If you have cut a lot of logs with it, it may be that the wedge is dull or nicked. However be careful when taking the pull start off because once you do you might have to reset the pull start. It was aggravating to use.

Another $75 or make your own. I have an energy splitter valve on a 33 ton troy built log splitter that wouldn't detent properly. So i bought a countyline 25 ton splitter from tcs about 2 months ago.

Grasp the two ends firmly and separate the two wires at the connector. The tractor supply stores here in nj offer the same $100 off but start at a higher $1,099. So far i have been very pleased with it, it cranks on the first pull most often and the splitter has grunted a few times but i haven't had anything yet that it couldn't split.

Twist the screw on the side of the pump clockwise with a flat blade screwdriver to increase pressure, according to the scale printed or embossed on the side. It didn't work properly when brand new. Now i start it up about 9 months later and it will not stay running.

Knowing precisely what is wrong with your log splitter is the first step to repair. 22 ton county line wood splitter. Hydraulic cylinder won't extend the wedge.

The size and positioning of logs in your yard machine log splitter is very important. I purchased the huskee 22 ton on 7/31/14 and it has a kohler on it. Keeping them won’t be a good idea.

The way to tell is to take the pull start off the engine and see if the engine shaft will turn by hand. Accessing the flexible pump coupler is fairly easy, so check. 3 years material and workmanship/2 years engine/1 year hydraulic components.

As noted, it performs better than the old 27 ton unit and is much quicker, quiter and easier on fuel. Follow this wire until you locate the green quick connect. It’s got a few practical features, such as the ability to split logs horizontally or vertically.

If you keep enough hydraulic fluid in the reserve tank, the oil pump should be in good working order. I used it last winter and everything worked perfect. A broken flexible pump coupler, clogged hydraulic fluid filter, failed hydraulic control valve, broken hydraulic pump or faulty hydraulic cylinder can prevent the hydraulic cylinder from extending the wedge on a log splitter.

Locate the yellow wire on the crankcase. I disassembled the valve completely to inspect it. I want a log catcher/table.

Nov 10, 2017 6 montana. I've worked on hydraulic equipment for 35 years and decided to correct it. Replace worn log splitter parts.

A dirty carburetor, bad gasoline, failed spark plug or broken recoil starter can prevent the log splitter engine from starting. The sensor may stick on engines that have not been run for long periods of time. This is especially true of your hoses.

How to fix the pull cord starter on wood splitter machine. Be sure to compare the part and model number before purchasing new parts. The hydraulic pump controls the flow of fluid within the pump system.

Replace the worn parts of your log splitter as soon as possible. Sharpen the wedge and replace it. 11.5 second cycle time and kohler engine.

Shawn Davison Alwaysshineinglight79 - Profile Pinterest